Technical Articles

Teflon conveyor belt slippage causes and treatment methods

Teflon conveyor belt slip is one of the most common failures of conveyors using Teflon conveyor belts. There are many reasons for slipping. The main reason is the low installation accuracy and poor daily maintenance. The following are some common reasons and solutions for the maintenance of conveyors using Teflon conveyor belts.


Teflon conveyor failure phenomenon: Teflon conveyor belt slips.


Teflon conveyor failure reason: When the Teflon conveyor belt is in normal operation, the belt speed should not be lower than 95% of the roller speed. If the friction between the surface of the drum and the Teflon conveyor belt is insufficient, the Teflon conveyor belt is prone to slippage. There are many reasons for the insufficient friction between the roller and the Teflon conveyor belt. Common ones are: load start, insufficient friction coefficient on the surface of the roller, and insufficient tension. The reasons for the insufficient friction coefficient on the surface of the roller are: the surface of the roller is too much worn, the belt is too wet or sticky, the surface of the belt is stuck with material (easy to be melted by water); the reasons for insufficient tension are: Zhang The tight stroke is not enough, the weight of the counterweight is not enough, and the Teflon conveyor belt is too long.


Trouble solution for Teflon conveyor: clean the surface of the roller, dry the Teflon conveyor belt, clean the Teflon conveyor belt, adjust the tension stroke, increase the weight of the counterweight, and shorten the length of the Teflon conveyor belt.

Tip: Tip: This article is automatically translated by Google, the original Chinese version: https://www.jsww.net/tech/25-cn.html